Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Kalahari Manufacturing LLC, 171 Progressive Drive, LAKE DELTON, WISCONSIN 53940
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
While cutting branches with a table saw, an employee suffered a severed little finger and severe lacerations to two other fingers.
An employee was cutting wood on a table saw when the wood kicked back and the employee's hand slipped, making contact with the saw blade. The left thumb was amputated at the knuckle.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.
An employee was climbing an 8-foot ladder to clean windows on a house. The employee was reaching to the right when they lost their balance and slipped. The employee fell and their foot became caught in the ladder rungs, causing both the employee and the ladder to fall to the ground. The employee sustained a fracture to the right leg requiring hospitalization and surgery.
An employee was offloading material using a forklift when the hoisted material began shifting. The employee went to manually stabilize the load and their right middle fingertip was pinched and amputated.
An employee was packing candles on a line. They reached down to pick up a 12-pack of candles when their right little finger was caught in the conveyor belt, resulting in an amputation at the distal joint.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.