Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Madix, Inc., 500 Airport Road, TERRELL, TEXAS 75160
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was cutting a piece of steel. The saw blade caught the employee's right thumb, causing a partial amputation.
An employee was feeding scrap metal into a chipper when his right hand was squeezed against a metal component of the machine. He suffered an amputation to the right index finger at the second joint.
On April 10, 2025, an employee was operating a brake press when two of its dies pinched her left ring and middle fingers. She suffered amputations to both fingertips, just above the fingernails. The machine was guarded with a light curtain at the time of the incident.
An employee was using a forklift to move a piece of angle iron. The angle iron slipped off the forklift and hit the employee's right foot resulting in a toe amputation.
An employee was manufacturing parts on a roll former machine. He went to remove the parts and his right hand became caught between the parts and the guard, resulting in partial amputation of his ring finger.
On March 23, 2023, at approximately 9:00 AM, an employee was operating an automated saw. As the employee went to adjust the coolant sprayers, the rotating blades caught his glove and pulled his hand in, resulting in three left-hand finger amputations.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332311)
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.
An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.
An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.