Fall through surface or existing opening 11 to 15 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at R & D METAL FABRICATION, INC., 2407 SOUTH UNIROYAL RD., OPELIKA, ALABAMA 36804
on — Fractures, affecting the leg(s), unspecified.
Final narrative
While working from a roof, an employee fell through a skylight to the concrete floor about 14' below, suffering a broken left leg.
An employee was checking an HVAC unit in the attic when they fell approximately 15 feet through the rafters to the floor. The employee sustained fractures to the ribs and scapula as well as a collapsed lung.
An employee was removing grating to change metal chip hoppers located in a pit. The employee lost his balance and fell approximately 12 feet from the grate, landing in the metal chip hopper. The employee sustained a sprained right foot, a left foot fracture, and a fractured L5 vertebra.
An employee was reviewing the next steps to take with the foreman when some material fell from above and landed near them. The injured employee then looked up, took a step on the catwalk, and fell through a gap, landing on the ground 15 feet below. The employee sustained three fractured vertebrae and a head laceration.
0n November 16, 2023, an employee was climbing onto a catwalk to cut valves for unit heaters in a building. The employee fell 14 feet through the attic onto the concrete floor, resulting in a fractured pelvis.
An employee was removing a rooftop curb when they fell approximately 15 feet through an opening in the roof, resulting in a fractured leg that required hospitalization.
More severe injuries in this industry (NAICS 332322)
An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
An employee was performing routine maintenance on a shear machine when the machine's foot pedal was engaged and the blade contacted his right middle finger, resulting in a partial amputation.
An employee was helping to tighten down a metal packaging band for shipping. The metal band broke and struck the employee across their face, cutting their left face/eye area. The employee was hospitalized.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.