Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Westgate Products LTD , 50 W Fernau Ave, OSHKOSH, WISCONSIN 54901
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was working on a PNC forming machine when the employee made contact with the grinding wheel on the machine, resulting in amputations to the right index fingertip and thumb tip. The machine was not locked out at the time of the incident.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was using straps to secure a load inside a transport trailer. The employee was standing on a stack of finished goods that was three pallets high. Each pallet was 16 inches high. He was walking from the stack of three pallets onto a stack of two pallets when he lost his balance and fell onto another stack of finished goods (that was two pallets high) and then landed on the floor of the trailer. The employee was hospitalized with fractured ribs.
An employee was unclogging a resin sifting machine. The rotary sifter's automatic system activated and the sifter blade struck the employee's fingertip, causing an avulsion. The fingertip was medically amputated.
An employee was helping to remove a roll of plastic from a line when the tail stock on the machine snapped back and caught the employee's right middle fingertip, resulting in a partial amputation.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.