Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Ouachita Hardwood Flooring, 501 Pennington Rd, WARREN, ARKANSAS 71671
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was on the back side of a knot saw when he bent over to pick something up. He then placed his left hand on the top of the saw and reached over the saw with his right hand. As he reached across the saw, he pressed down on the top and his left hand slid over the blade, resulting in the amputation of his left index and ring fingers at the first knuckle.
An employee was attempting to cut wood flooring to size with a chop saw. He mashed down on the steel plate on top of the saw blade guard with his left hand while his right hand was near the blade. The blade then severely lacerated his right hand and amputated his right pinky fingertip. The saw was guarded at the time of the incident.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was adjusting the height of an ultraviolet (UV) lamp. She was electrocuted by the UV machine. She sustained burns on her left hand and an entry wound on the right forearm. The employee was hospitalized.
On August 14, 2025, an employee was rebuilding a tile-cutting die when their right wrist contacted the cutting blade, resulting in a laceration that required hospitalization.
An employee was removing a jammed piece of scrap wood from the end of a machine saw when the wood pulled their right hand into the saw blade, resulting in an index finger amputation below the second knuckle.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.