Meyer's RV Centers, LLC

An employee was stepping over a wooden 2-by-4. The wood caught the employee's foot and the employee fell to the ground, landing on their right leg and hip. The employee's femur was broken at the hip joint.

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was working on disassembling and moving a trailer house from a gas well pad. The employee was on the roof of the structure installing flashing. The employee fell to the ground below, sustaining a skull fracture and brain bleed. The employee was hospitalized.

An employee was working on a truck when the truck's door fell on his hand, resulting in a partial amputation of the little finger.

The injured employee had been working on the computer at the front desk in the showroom. An argument occurred with another employee and additional people got involved. Gunshots were fired. The employee was shot in the hip and was hospitalized.

An employee was working on the lift gate of a truck when their left ring fingertip got caught in a pinch point, resulting in amputation.

An employee was preparing to remove leaf spring bushings on the front drive axle of a tandem axle tractor. After raising the axle with a hydraulic jack, he placed two jack stands under the rear frame rails of the tractor and placed additional jack stands under the front drive axle. He then repositioned himself at the rear of the tractor where he reached for the release valve of the jack to begin lowering the axle (and frame) onto the jack stands. He was in a kneeling position while using his right hand to operate the release valve. His left hand was caught between the lowering frame rail and a jack stand. His left ring and middle fingertips were crushed, resulting in amputations.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.