Other fall to lower level less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Niagara Transformer Corp., 1747 Dale Rd., CHEEKTOWAGA, NEW YORK 14225
on — Fractures, affecting the lower leg(s).
Final narrative
An employee was standing on the second or third step of a 6-foot step ladder, guiding a control box door with a pry bar. The pry bar slipped and he lost his balance and fell to the floor, breaking his right upper tibia below the kneecap.
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 335311)
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
An employee was troubleshooting a machine. He was investigating a slipping belt when it caught his left hand and pulled it into a pulley, partially amputating the tip of his thumb.
An employee was tilting a radiator in a fixture. The radiator moved in the fixture and crushed the employee's left index fingertip, causing an amputation.
An employee installed a busbar on a coil for a winding machine. The busbar hit a tension bar, causing his left ring finger to get caught between the coil and the tension bar, which pulled in the employee's glove and resulted in a medical fingertip amputation. The machine was guarded at the time.
An employee was operating a wire winding machine when their clothing was caught in a rotating component, pulling them into the equipment. The employee's right arm was fractured.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.