Natural State Recycling

Two employees were processing a bale of mixed plastic bottles and other material for recycling. When the strand of wire was cut, the cut end whipped around and struck the outer edge of an employee's eye. The employee was hospitalized and underwent surgery.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee was stepping down from his truck when he slipped and fell, twisting his ankle. The employee's ankle was fractured and he was hospitalized.

An employee was working on a loading ramp that was stuck open (upright). The employee went under the ramp to release it. When he pulled on a chain that was holding the ramp open, the ramp came down rapidly, striking the right side of his face (cheek) and the right side of his neck. The employee was hospitalized.

An employee was cutting off bracing from an 8 x 12' metal wall when the wall fell, striking the employee on their side and back. The employee sustained bruised ribs and two fractures in their back.

An employee was collecting trash on a residential garbage route. He became weak and unwell and was hospitalized, suffering from heat exhaustion.

A driver was climbing the rear trailer ladder to facilitate tarping when they lost balance, slipped, and fell approximately 6-8 feet to the ground. The employee sustained a fractured wrist.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.