Pinnacle Structures, Inc.

An employee was unloading a metal rafter with an overhead traveling joist crane when the crane's clamp caught the edge of the rafter, causing the crane to tip over onto the employee. The employee suffered a broken right leg.

An employee was on a two-step ladder performing cleaning activities in the de-oiler machine. The employee fell back and his right arm was caught in the equipment, resulting in a right forearm fracture that required surgery.

An employee was changing an insert in the tool head of a CNC machine. The employee had stepped up approximately 28 inches onto the door track of the machine. When the employee went to step back down to the floor, they lost balance and fell backward onto a rack of metal parts. The employee sustained a compression fracture to the spine.

An employee was packaging steel coils on a turntable. As he walked across the turntable, he slipped and fell onto a coil. His left bicep was lacerated by the slit edge of a coil.

An employee was monitoring a lumber-stacking machine when they slipped and fell into an unbanded bundle of lumber. The outer row of lumber then fell on their left leg, fracturing their leg and ankle.

An employee was putting parts away in a warehouse. He tripped and fell into metal shelving, resulting in a broken arm.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.

An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.

An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.

An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.