Eshbro Construction LLC

An employee was straddling a beam approximately 19 feet above the ground when he lost his balance while preparing to connect a beam being hoisted into place by a crane. He fell to the ground, striking dirt and the first course of cement block around the building's foundation. He fractured his nose and arm and was hospitalized overnight.

An employee was laying down bridging (angle iron that is welded onto open web joists). He was moving backward toward the edge of a joist when his foot slipped. He lost balance and fell backward away from the structure and landed on the ground about 30 feet below. The employee sustained a broken right leg. The employee was wearing a harness but it was not connected at the time of the fall.

An employee fell approximately 30 feet from a roof, resulting in head and spine injuries.

On June 16, 2023, an employee was checking the I-beams on a bridge. He unhooked his harness to move across the section of the second beam. While hooking his harness on the third beam, his foot hit the cable that was connected to the beam and fell approximately 25 to 30 feet to the muddy clay floor below. The employee sustained a left hip and femur fracture.

An employee was using a 60-foot ladder to access the fourth floor of a building in order to paint the balcony. The employee was holding onto the handrail while painting it when the handrail brackets broke, causing him to fall approximately 30 feet to the ground and land on top of air conditioning units. The employee suffered severe lacerations on the face and fractures to the cheekbones and eye bones. The employee was hospitalized.

An employee entered a portable structure that was being rigged up to a crane. The crane began lifting the portable structure with the employee inside when the structure fell 15-30 feet to the ground. The employee sustained a left leg fracture, a dislocated right ankle, and back injury.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.