North Texas Contracting, Inc.

An employee was starting a large ventilation blower. Fire/gasoline shot out of the blower and burned his left shoulder and underarm.

While climbing down a ladder, an employee slipped off the ladder and fractured an ankle.

An employee was trying to remove a T-post fencing stake using a stake remover tool. While using his body weight to push down on the lever, his leg twisted and broke. He was hospitalized, requiring surgery.

The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.

On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.

An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.

Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.

An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.