Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Vulcan Industrial, Alabama Power , BUCKS, ALABAMA 36512
on — Amputations, affecting the fingertip(s).
Final narrative
Employees were cutting and bending metal using a manual sheet metal brake. The brake closed on an employee's left hand, causing the amputation of the index fingertip.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 532490)
An employee was pulling a data cable through a ceiling. He fell through the ceiling, landing at ground level. He suffered a laceration to the forehead, a dislocated left little finger, a broken left ring finger, and a laceration to the liver.
On September 16, 2025, an employee was installing and adjusting spotlights on a performance stage that was under construction. While crossing the stage to speak with other contractors, the employee encountered a section of the stage where the elevation changed to a lower level. As the employee stepped down 14 inches to the lower level, his knee locked up and he fell to the stage. He subsequently rolled off the stage and fell approximately 2 to 3 feet to the floor, resulting in a fractured tibial plateau in his right leg.
An employee was delivering a 65-foot boom lift to a rental customer's construction site. The employee set up the ramp truck in the parking lot adjacent to the construction site. He elevated the boom 4-5 feet to clear a temporary fence. While driving the boom lift off the ramp, the wheels slid to the driver's side of the ramp truck, ultimately sliding off the ramp. The boom lift fell off the side of the truck and rolled onto its side. The employee sustained a fractured clavicle, a dislocated shoulder, separated/fractured ribs, a punctured lung, and a fractured left femur. The employee required surgery.
An employee was performing maintenance on a telehandler and installing a carriage lift cylinder. The employee was checking the alignment when the cylinder slipped and partially amputated his left middle finger.
An employee had just serviced a battery and was reinstalling it in a forklift using a battery extractor. The employee was trying to pull the battery out of the battery compartment when the extractor moved, causing the battery to shift on the rollers. The employee's right hand was crushed between the top of the battery and the battery compartment.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.