WestRock Company of Texas

An employee was adjusting a belt guide under a cutting machine. His right hand was pulled between two rollers and the index and middle fingers were injured.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee worked a shift and later experienced cramping in his arms and legs. He was hospitalized with dehydration.

An employee worked in the paper machine area for a shift, cutting corners off paper rolls around the roll machine. Afterwards, the employee sustained cramping and dehydration due to heat. The employee was hospitalized.

An employee was adjusting a trim sheet leading to a sheeter machine. Their glove became caught in the machine and the shearer closed on the employee's right hand, crushing it and breaking the hand and wrist.

An employee was troubleshooting a process upset. A nearby refiner had a pressure spike, causing the housing to separate slightly, which allowed the loss of primary containment. The employee was sprayed by hot water, resulting second- and third-degree burns on his torso and left arm.

On July 22, 2024, at 10:30 AM, an employee was responding to a pulp mill manufacturing process shutdown. Pulp stock overflowed through an engineered overflow pipe resulting in a buildup of stock in a bermed area. The stock was 140 to 150 degrees. The employee went to the bermed area to close an air-actuated process valve. While closing the valve, pulp stock entered the top of his boots and caused second-degree burns to both of his lower legs down to his feet. The employee was hospitalized.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.