Pine State Trading Co.

An employee was trying to move a pressure vessel when it fell over. A stud on the top of the vessel struck and gouged the employee's stomach.

An employee was standing a steel bar on its edge when the bar fell onto his left hand, resulting in a middle fingertip amputation.

An employee was unloading the dishwasher and dropped a glass, resulting in a left hand laceration that required hospitalization.

An employee was removing a jam from a blancher. As he went to remove the blade, he dropped it, lacerating his leg.

An employee was mounting a TV when they dropped it. The employee suffered a partial amputation of the left index finger.

An employee was traveling on a walker rider as it headed for the outer wall of the warehouse office. He jumped off the front of the rider which caused his legs to be caught between the base of the rider and the yellow safety rail. The employee sustained a fractured right fibula.

An employee was reversing a forklift when it struck a building-support column and the employee sustained a spine injury.

An employee was delivering a keg of beer when he lost balance and dropped the keg on his right foot/big toe. The employee's right foot/big toe were fractured and required surgery.

An employee was selecting cases in a warehouse when they were struck by a pallet jack, resulting in a crushed right ankle that required hospitalization.

An employee parked their truck and was lowering the lift gate to unload and service an account at a convenience store. A vehicle pulled out from a parking spot and pinned the employee against the lift gate. The employee sustained a leg amputation.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.