Jerdan Services, Inc.

On November 9, 2023, an employee was removing plywood from the west face of a basement level buck hoist to prepare to dismantle one of the cabs. When the employee pulled on the plywood, it fell and pulled a rope that partially amputated the employee's thumb.

An employee was holding a rigging line and assisting in the removal of an old light pole from its base. When the load was lifted by a forklift, it shifted. The tag line lifted the employee off the ground and propelled him through the air. The employee landed on the ground and sustained back fractures.

An employee was performing maintenance on a bucket truck when his right hand became caught in some rope, causing amputations to three fingers down to the first knuckle.

An employee was conducting a fall rescue demonstration. A 165-pound demonstration dummy was released from a height, putting tension on the lanyard. The employee's left hand, little finger, and thumb were caught in the wire rope lanyard, resulting in a medical amputation of the left little finger as well as lacerations to the left thumb.

An employee was using a crank and cable to lower a light tower due to windy conditions. The light shaft became hung up and released the tension in the cable, which wrapped around the employee's left hand, resulting in amputations of three fingers.

At 12:55 p.m. on October 8, 2025, a pneumatic cylinder press was activated while an employee's hand was resting on it. The moving shaft and top portion of the machine descended, catching the employee's right middle finger and amputating the fingertip (without bone loss).

An employee had been providing lawncare service and was driving back to the main facility when he experienced severe cramping due to heat stress. The employee was hospitalized for dehydration.

At about 5:15 p.m. on June 14, 2025, an employee was using a walk-behind mower to mow middle islands along a road. A support truck with an arrow board sign was following behind to control traffic. The truck lurched forward and struck the employee from behind, pinning the employee against the mower. The employee suffered a fractured hip, a right iliac wing fracture, right femoral nerve damage, and puncture wounds to the right leg. The employee was hospitalized.

A welder in the fabrication shop was straightening a wheel tab with a hammer and struck his left hand. The employee was hospitalized with a fractured hand.

A sprayer boom assembly fell off a sawhorse when the C-clamp was removed and it struck an employee. The employee suffered a separated collarbone and three broken ribs.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.