Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Haldex Brake Products, 6800 Geyer Springs Rd, LITTLE ROCK, ARKANSAS 72209
on — Amputations, affecting the fingertip(s).
Final narrative
A temporary employee was using a de-riveter machine to remove rivets from a brake shoe. The employee placed a sheet of material down on the table of the de-riveter and then placed the brake shoe on top of it. The employee held the brake shoe in place on the table and engaged the de-riveter. During the machine's cycle, the brake shoe shifted on the surface and crushed the employee's right ring fingertip between the shoe and the de-riveter table, resulting in amputation of the fingertip.
AmputationFingertip(s)Metal, woodworking, and special material machinery, n.e.c.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 336340)
On March 26, 2025, at approximately 11:45 AM, an employee was operating a forming machine and sustained the amputation of their right middle finger. The machine was guarded at the time.
An employee was throwing garbage into a baler when they slipped, twisted their knee, and fell on their backside. The employee sustained a sprained left knee and was hospitalized.
On May 15, 2024, an employee was emptying a scrap hopper with a powered industrial vehicle (PIV) when their left hand was caught between the scrap hopper and the PIV fork. They sustained an amputation of the ring fingertip.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.