TEREX ENVIRONMENTAL EQUIPMENT

An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.

An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.

Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.

An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.

An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.

An employee was cleaning the floor by a belt conveyor when their right arm contacted the pulley/belting. His arm was pulled into the conveyor assembly, resulting in a fracture to his upper arm.

A backhoe tractor was moving gravel into a 1-foot-deep trench, and an employee was helping spread the gravel. The trench had been partly filled and the tractor was returning to it with a load of stone when its raised bucket struck the employee, who was standing in the trench. He was hospitalized, having suffered an abdominal injury that caused internal bleeding.

An employee was correcting a bend on a brake press when their left middle finger was crushed in the machine.

An employee was inside the frame of a traveling water screen that was up on sawhorses. The employee was working to fit a foot-shaft assembly onto the boot section when their left index finger was crushed and fractured between the sprocket and the set collar or chain. The fingertip was amputated.

On July 26, 2025, an employee was assembling a custom-designed automation line. During troubleshooting, he made contact with a photoelectric sensor that was part of the machine s part detection system. This triggered a small pneumatic crimping cylinder, which activated and came down on the tip of his right thumb, resulting in a partial amputation without bone loss.

An employee slipped while climbing a ladder on a skidder, fell to the ground, and suffered a tibia/fibula fracture. The employee was hospitalized.

An employee was lowering the bucket of a track loader that contained a grade stake and the grade stake punctured his foot, resulting in hospitalization and surgery.

An employee was using a pike to move a pallet of sugar that was stuck in the powder racking. The employee fell backward, landing on his right leg. The employee's leg was fractured and he was hospitalized.

An employee was working to fix the forks on a forklift when the fork(s) fell on her toes. The second and third toes on her right foot were fractured, lacerated, and required stitches.

An employee was delivering a 65-foot boom lift to a rental customer's construction site. The employee set up the ramp truck in the parking lot adjacent to the construction site. He elevated the boom 4-5 feet to clear a temporary fence. While driving the boom lift off the ramp, the wheels slid to the driver's side of the ramp truck, ultimately sliding off the ramp. The boom lift fell off the side of the truck and rolled onto its side. The employee sustained a fractured clavicle, a dislocated shoulder, separated/fractured ribs, a punctured lung, and a fractured left femur. The employee required surgery.