P&K Equipment, Inc.

An employee was observing the installation of a boom mower which was being moved by a forklift. When the load was relieved from the forklift on the left side, the assembly shifted toward the forklift and out of alignment with the tractor. The forklift operator attempted to reposition the load balance; however, the load shifted forward and the right side of the assembly dropped off the forks to the ground, striking the employee's right foot. The right foot was crushed and the tibia, fibula, and heel bone were broken.

On December 26, 2023, an employee went out to the parking lot to troubleshoot the starter of an SUV. The employee was underneath the vehicle when it started and moved and the employee's middle back area was caught under the front passenger-side tire. The employee sustained a fractured collar bone.

An employee was parking at a patient's home and exited the van to manually open the garage door. The van began rolling backward and rolled over the employee's right leg. She was hospitalized with a fractured leg.

A driver exited their truck so they could provide service for a customer when the truck began to roll away. The driver went to re-enter the truck but fell and was struck by the rear driver-side tire. The employee sustained fractures to their leg and foot.

An employee had been operating a yard tractor. He parked the vehicle and was exiting when the vehicle began to roll, causing him to fall. The employee's hand was then run over by the yard tractor, resulting in fractures to multiple fingers. The employee was hospitalized.

An employee was checking for a leak in the air brake system of a semi-truck. The employee had removed the brake chamber when the truck rolled back. One of the tires pinned the employee's right hip against the ground.

During a break, an employee was engaged in a conversation with a customer. They were standing approximately 7 feet in front of a combine header that was attached to a payloader but also set on jack stands for support. The header dislodged from the payloader, slid forward along with its support stand, and struck both the employee and the customer. The employee was hospitalized with fractures to thoracic and lumbar vertebrae, a fractured rib, and a partially deflated lung. The customer also sustained injury.

An employee was replacing a manure belt in an egg producing poultry house. He was using a mechanical roller and a steel cable to pull (remove) the old manure belt. The employee's ring and little fingertips were pinched between the roller and the cable resulting in partial amputations above the top knuckle.

An employee was walking past a cow barn when he slipped on a wet floor mat and fell. The employee sustained torn ligaments and his quadriceps were torn from the bone on both legs.

An employee was working on a bale accumulator attached to a tractor. While he was making adjustments, the accumulator activated. The bar of the accumulator struck him and dragged him to the side, and his right leg was run over. He suffered a broken femur.

An employee tripped on a piece of wood and fell onto the rough edge of a metal tank under fabrication. The employee was hospitalized with a laceration on his hand.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.