Oakley Grading and Pipeline LLC

An employee was standing on a bag of bentonite clay composite when it ignited and the employee's pants leg caught on fire. The employee then went to remove a gasoline can from a dual-axle trailer and sustained burns to his arms, right hand, and the right side of his abdomen.

An employee was burning a brush pile. They poured gasoline on the fire, resulting in burns to his face, arms, and hands.

An employee was helping to put out a fire in a wok when hot cooking oil splashed onto the employee. They sustained second-degree burns.

Two employees were working on an empty above-ground 2,500-barrel crude oil tank. Employee 1 was welding while employee 2 was watching. Employee 1 saw fire behind the welding smoke and notified employee 2. Before they could get off the tank, they both fell in the tank and sustained burns from the fire.

An employee was pressing pyrotechnic composition into pellets using a pressure tablet press. Upon pouring the composition into the small hopper, the composition ignited and produced a flash fire. The employee sustained bilateral burns to the hands and face.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.