L.L. BEAN, INC.

An employee was leaving work at the end of the shift, slipped on black ice, and fell fracturing the left ankle.

An employee was going to the breakroom when they tripped over a chair and fell, resulting in a hip fracture.

An employee arrived at work and was walking into the store through the parking lot. The employee tripped over a curb and fell to the ground, sustaining a femur fracture.

An employee tripped over a box and fell to the floor, fracturing their right arm.

An employee tripped over a piece of angle iron and fell to the floor sustaining a broken hip.

An employee was preparing for a CT scan when she tripped over a loose strap and fell to the floor, fracturing her hip.

An employee had just retrieved a roll of packing dunnage. The employee tripped while stepping off a pallet, fell to the concrete floor, and suffered a broken right hip.

An employee was carrying a box of blinds (approximately 36 pounds and 6 feet long) down a small flight of exterior concrete stairs at the customer s preferred delivery location. He fell down the last two steps to the concrete ground below. The employee sustained a dislocation of his right knee and a torn patellar tendon, requiring hospitalization and surgery.

An employee was operating an electric pallet jack (EPJ) and making a U-turn when they became caught between the pallet jack and racking. The front part of their foot was pinned between the racking corner guard and the EPJ platform. The employee sustained lacerated tendons to the right big toe that required surgery.

A mail carrier was delivering mail when she was attacked by a dog, causing her to fall to the ground and hit her head on the concrete. The employee lost consciousness and was hospitalized with a concussion and an internal head injury.

An employee was adjusting a set of retractable (manual) conveyor rollers. The employee's hands were under the rollers when the rollers were pushed toward him. His fingers were caught in a pinch point, resulting in the amputation of his left index finger at the first knuckle.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.