L A Darling Store Fixtures (Paragould Plant - Hwy 49)

An employee was walking to their truck to look for a lid. When they stepped between the truck and a dock plate, they sustained a knee injury that required surgery.

An employee was standing on plant bed timbers, using a powered hand trimmer to trim the shrubs in the plant bed. The timber gave way, breaking into several pieces. The employee lost balance and fell with the trimmer in his hand. He suffered a severe laceration to the right wrist and hand.

A mail carrier slipped on ice and sustained a strain that required hospitalization.

An employee was loading phosphoric acid onto a rail car and preparing to secure the rail car for transport. While repositioning the loadout spout to secure it back to the drip pan holster on the dock, the spout contacted the handrail of the rail car, causing the employee to lose balance. The employee stepped back and their right foot entered the opening for the rail car, causing him to twist/pivot on his left leg. The employee's lower left leg was fractured.

On November 14, 2023, an employee was receiving a delivery from a truck when some of the merchandise fell from the truck s lift and struck him. He then fell to the ground and his head struck the sidewalk, resulting in an injury that required hospitalization.

On August 13, 2025, an employee was feeding wire through a junction box to feed a 120-volt circuit near a 480-volt bus duct. The bus duct suddenly combusted, and the employee suffered burns to his left hand and upper body. He was hospitalized.

An employee was operating a brake press and making the final bend on a steel part. Her right middle finger got caught between the part and the top punch as it bent the part upward. The employee sustained a crush injury resulting in amputation of the fingertip.

An employee was feeding scrap metal into a chipper when his right hand was squeezed against a metal component of the machine. He suffered an amputation to the right index finger at the second joint.

An employee was setting up a press brake when the machine was activated and her left middle fingertip was caught between the dies and amputated.

On June 18, 2025, an employee working as a millwork installer was cutting shims using a circular saw. The saw hit a knot in the wood and jumped, cutting the palm of the employee's left hand and causing partial amputations to three fingers. The employee was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.