Action Carting Environmental

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was performing maintenance on a hopper. The employee's hand was caught in a cylinder pivot point area when the pneumatic cylinder released trapped air. The cylinder crushed the employee's left little finger, causing the partial amputation of the fingertip.

An employee was opening a door to a semi trailer at the facility and his hand was caught between the door and another parked semi. The employee's left index finger was fractured and thumb muscles were injured. The employee was hospitalized and required surgery.

An employee was removing residual meat particles from the sprocket of the crossover conveyor belt in the packing area. While doing so, the conveyor started and his fingers were caught between the metal framework and the belt, resulting in amputations to the middle and ring fingers on the left hand as well as skin damage to the right hand.

An employee was unloading vehicles. While unloading a van, the brakes failed and the vehicle rolled off the car hauler and ran over the employee. The employee was hospitalized for a lower left leg fracture.

An employee was servicing the compactor. They were reconnecting the turnbuckle on a receiver box when the turnbuckle slipped and fell, crushing the employee's left middle fingertip. The employee was hospitalized for surgery.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.