Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Conestoga Wood Specialties Corporation, 245 Reading Rd, EAST EARL, PENNSYLVANIA 17519
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was pushing a 5-inch by 8-inch piece of wood through a table saw blade. The saw blade amputated the employee's left index fingertip.
AmputationFingertip(s)Table saws
More severe injuries at Conestoga Wood Specialties Corporation
An employee was clearing a small piece of wood that had jammed in the back of a machine. A cutting blade in the machine lacerated the employee's right forearm. The employee was hospitalized, requiring surgery.
A forklift had just placed a pallet on the third or fourth level of some racking. The pallet fell through the racking and struck an employee's head, then trapped his lower body under it. He suffered a head laceration and lower extremity injuries.
A doorframe assembly press activated while an employee was adjusting the clamps on the machine, and their right index finger was caught between the press's clamp and a doorframe. The fingertip was amputated.
An employee was repositioning a wooden board that did not feed properly into a saw. The board then became jammed. The employee reached to grasp the board and their left middle finger became stuck between the fence and a moving chain, resulting in a fingertip amputation.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee fell to an office floor, landing on her right side and suffering a broken hip, a broken right arm, and a concussion. She was hospitalized, requiring surgery.
An employee was clearing a small piece of wood that had jammed in the back of a machine. A cutting blade in the machine lacerated the employee's right forearm. The employee was hospitalized, requiring surgery.
An employee was operating a stand-up forklift to travel from the warehouse to the breakroom area. The forklift struck the breakroom wall, causing a fracture/crush injury to his left foot.
An employee was cutting a piece of wood with a table saw. The wood bound in the saw, which then pulled the employee's right hand into the blade. His middle finger was cut and fractured.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.