Hill Services Industrial & Environmental

An employee was hydro blasting a vertical pipe with a lancer to unclog the pipe. When the material that was clogging the pipe broke free, it knocked the lancer out of the pipe. The employee was then hit on the left arm by the lancer water pressure, suffering a laceration.

An employee was installing wood trim surrounding a skylight inside a home. While holding a piece of trim in it's desired location, his pneumatic nail gun discharged, sending a 3/4-inch pin nail into his left forearm.

An employee removed a safety valve on a trailer that unknowingly contained nitrogen gas. The gas released from the trailer and pushed the employee backward off a scaffold approximately 10 feet before they struck a garage door, resulting in a pelvic injury.

An employee was sitting at her workstation when a nail gun malfunctioned and shot a nail into her left leg. She suffered a puncture and blood vessel injury and was hospitalized.

On November 25, 2023, an employee was using a high-pressured water hose to perform sewer line cleaning operations. The employee's right little finger and palm were lacerated by pressurized water from the hose.

An employee was hydroblasting when they slipped and the pressurized water stream lacerated their left ankle.

An employee was performing maintenance on a hopper. The employee's hand was caught in a cylinder pivot point area when the pneumatic cylinder released trapped air. The cylinder crushed the employee's left little finger, causing the partial amputation of the fingertip.

An employee was opening a door to a semi trailer at the facility and his hand was caught between the door and another parked semi. The employee's left index finger was fractured and thumb muscles were injured. The employee was hospitalized and required surgery.

An employee was removing residual meat particles from the sprocket of the crossover conveyor belt in the packing area. While doing so, the conveyor started and his fingers were caught between the metal framework and the belt, resulting in amputations to the middle and ring fingers on the left hand as well as skin damage to the right hand.

An employee was unloading vehicles. While unloading a van, the brakes failed and the vehicle rolled off the car hauler and ran over the employee. The employee was hospitalized for a lower left leg fracture.

An employee was servicing the compactor. They were reconnecting the turnbuckle on a receiver box when the turnbuckle slipped and fell, crushing the employee's left middle fingertip. The employee was hospitalized for surgery.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.