Struck by rolling object or equipment being pushed by injured worker · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Aquifer Drilling and Testing, Inc., 5951 Queens Midtown Expwy., MASPETH, NEW YORK 11378
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was loading a 5-foot auger drill bit onto a flatbed truck. His right pinky finger was caught between the auger he was rolling and another that was already on the truck. He sustained amputation of the pinky finger below the lower knuckle.
An employee was tightening straps to secure drill rods to the rack on the side of a drill rig. The drill rig operator was unaware that the employee's hand was on the drill rod rack and moved the drill rig, catching the employee's hand between the rig and rack. He suffered a dislocated wrist and damaged ligaments, requiring surgery.
An employee was taking a trash cart to a dumpster when one of their fingers was pinched between the trash cart and the dumpster, resulting in a partial amputation.
An employee was pushing flat shopping carts back into the cart tunnel. When unjamming the carts, part of the cart struck the employee's left shin, resulting in a laceration and bleeding. The employee was hospitalized.
An employee was pulling a cart backward in a storage area when his right little finger was pinched between the cart frame and an electrical box mounted to the side of a support column. The employee's right little finger was partially amputated.
An employee was helping to push a welding trailer out of the path of a truck. The trailer then rolled over a half-inch elevation change that rocked the trailer toward an electrical box. The employee's finger was pinched between the welding trailer and electrical box, resulting in a finger amputation approximately 1/2-inch from the end.
An employee was unloading packages from a trailer onto a cart. While moving the cart, it struck the employee's heel causing a tear to their Achilles muscle. The employee required surgery.
More severe injuries in this industry (NAICS 237110)
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.
Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.
An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.