TUSCALOOSA, ALABAMA—
S'N'S Erectors, Inc.
Other fall to lower level 21 to 25 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at S'N'S Erectors, Inc., Bryant-Denny Stadium, TUSCALOOSA, ALABAMA 35487 on — Fractures, affecting the chest, except internal location of diseases or disorders.
Final narrative
Two employees were on a lift torch-cutting an old connection plate off of a concrete beam and preparing to weld a new connection plate on when a concrete beam weighing approximately 68,500 pounds hit the lift and collapsed the basket. The employees fell approximately 21 feet with the basket to the ground, sustaining a spinal injury, broken ribs, and a facial injury.
Similar incidents · Same event type
DENVER, COLORADO—
First Generation Masonry, LLC
An employee was getting a tool bag that was on a second-story roof when they fell from the roof to the ground. The employee was hospitalized with injuries to their rib cage and lower back.
BELVIDERE, ILLINOIS—
Midwest Seamless Gutters and Siding Inc.
An employee was installing a clip on the roof when they slipped and fell approximately 25 feet to the ground below, resulting in a broken hip, broken leg, and bleeding in the brain.
MEDINA, OHIO—
Warren Roofing & Insulating Co. Inc
An employee was setting up the worksite for the day. While moving an extension cord, he fell backward off the roof of the two-story building and sustained a broken pelvis.
DENVER, COLORADO—
Carrera Services Inc.
An employee was going up in a lift to begin trimming trees with a chainsaw. He was approximately 20-25 feet in the air when the latch to the bucket got caught and detached. The bucket then tipped causing the employee to fall to the ground. He sustained fractures to his right elbow, right wrist, and left femur.
CEDARBURG, WISCONSIN—
A&M Contractors
An employee was laying down felt paper on a new residential property when they fell approximately 21 feet to the ground. The employee sustained fractures of the L2 vertebra, right tibia, and left wrist as well as a left heel dislocation. The employee was wearing fall protection at the time.
More severe injuries in this industry (NAICS 238120)
COLUMBUS, OHIO—
Foundation Steel, LLC
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
ATHENS, TEXAS—
Red Dot Corporation
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
JAMAICA, NEW YORK—
Cornell & Company, Inc.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
AUSTIN, TEXAS—
K Constructor, LLC
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
KINGS MOUNTAIN, NORTH CAROLINA—
Bowman Steel, LLC
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
More severe injuries in ALABAMA
GENEVA, ALABAMA—
Sysco Gulf Coast, LLC
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
BESSEMER, ALABAMA—
Norflex, Inc.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
ANNISTON, ALABAMA—
Ampler Pizza II LLC
An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.
ATMORE, ALABAMA—
Birdsong Corporation
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
ROGERSVILLE, ALABAMA—
Pilgrims
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.