Perlick Corporation

An employee was moving steel product on a metal table when the table tipped over and the product fell off and struck the employee's right foot.

An employee was installing wood trim surrounding a skylight inside a home. While holding a piece of trim in it's desired location, his pneumatic nail gun discharged, sending a 3/4-inch pin nail into his left forearm.

An employee removed a safety valve on a trailer that unknowingly contained nitrogen gas. The gas released from the trailer and pushed the employee backward off a scaffold approximately 10 feet before they struck a garage door, resulting in a pelvic injury.

An employee was sitting at her workstation when a nail gun malfunctioned and shot a nail into her left leg. She suffered a puncture and blood vessel injury and was hospitalized.

On November 25, 2023, an employee was using a high-pressured water hose to perform sewer line cleaning operations. The employee's right little finger and palm were lacerated by pressurized water from the hose.

An employee was hydroblasting when they slipped and the pressurized water stream lacerated their left ankle.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was holding a piece of rubber while it was being cut on a band saw. The saw blade amputated his right middle fingertip without bone loss.

An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.

An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.

An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.