Other fall to lower level 26 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at JDW Services, Inc., FM 2207 , GLADEWATER, TEXAS 75647
on — Fractures, affecting the arm(s), unspecified.
Final narrative
An employee was working to remove a section of catwalk that was approximately 30 feet high when he stepped from the catwalk section being removed onto the assumed catwalk to be left in place. The planking of the catwalk bent, causing him to lose his balance and fall to the ground. He suffered a broken right arm.
An employee was laying down bridging (angle iron that is welded onto open web joists). He was moving backward toward the edge of a joist when his foot slipped. He lost balance and fell backward away from the structure and landed on the ground about 30 feet below. The employee sustained a broken right leg. The employee was wearing a harness but it was not connected at the time of the fall.
On June 16, 2023, an employee was checking the I-beams on a bridge. He unhooked his harness to move across the section of the second beam. While hooking his harness on the third beam, his foot hit the cable that was connected to the beam and fell approximately 25 to 30 feet to the muddy clay floor below. The employee sustained a left hip and femur fracture.
An employee was using a 60-foot ladder to access the fourth floor of a building in order to paint the balcony. The employee was holding onto the handrail while painting it when the handrail brackets broke, causing him to fall approximately 30 feet to the ground and land on top of air conditioning units. The employee suffered severe lacerations on the face and fractures to the cheekbones and eye bones. The employee was hospitalized.
An employee entered a portable structure that was being rigged up to a crane. The crane began lifting the portable structure with the employee inside when the structure fell 15-30 feet to the ground. The employee sustained a left leg fracture, a dislocated right ankle, and back injury.
More severe injuries in this industry (NAICS 213112)
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.