Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Latco Truss, LLC, 2509 E Pridemore Dr, LINCOLN, ARKANSAS 72744
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was operating an up-cut saw to trim scrap material. The employee's left hand was in the point of operation when the saw was actuated via the foot pedal. The saw then amputated the employee's left middle finger to the second knuckle, the ring finger to the first knuckle, and the pinky fingertip.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was walking down the off ramp from a box truck, carrying a door for delivery. A strong wind caught the door, causing the employee to lose balance and fall about 2 to 3 feet to the ground. He landed on his back and suffered a broken vertebra.
An employee was delivering lumber to a customer's job site. He was using a truck-mounted forklift to transport the material to the staging area. The surface of the path of travel changed from asphalt to soil and rock with a slight downward grade. When the forklift moved onto the softer surface, it sank into the ground and its center of gravity shifted forward, causing it to tip over. The employee's right arm sustained a closed, supracondylar humerus fracture.
An employee was helping two forklift operators move and inventory flat sheet metal that was staged on racks. The metal fell off one side and struck the employee's arms and abdomen. The employee sustained a laceration above the left eye, a left forearm injury, and a ruptured spleen. The employee was hospitalized and required surgery.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.