Struck by swinging or slipping object, other than handheld, n.e.c. · Fractures and dislocations
At a glance
Federal OSHA recorded a severe workplace injury
at U.S. Department of the Army - Sierra Army Depot, Weld Shop, HERLONG, CALIFORNIA 96113
on — Fractures and dislocations, affecting the multiple trunk locations.
Final narrative
An employee was cleaning his work area when the strap holding a container rotator in a vertical position failed. The container rotator, and the container roll-in/out platform it was attached to, swung and struck the employee on the right upper torso and hip area. He suffered broken and dislocated ribs, a pelvic fracture, and fractures to lower-back vertebrae.
HospitalizedMultiple trunk locationsMaterial and personnel handling machinery, unspecified
More severe injuries at U.S. Department of the Army - Sierra Army Depot
Two employees were working together to load a jack onto the lift gate of a service truck. The injured employee grabbed the mount for the caster wheel to lift and push the jack onto the lift gate when the caster wheel swung around and pinched their left little finger. The employee fractured his left little finger.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 336992)
On May 4, 2025, at approximately 11:00 AM, an employee was using a table saw to cut notches in a piece of wood when the equipment kicked back, contacting their left index finger. The employee sustained an amputation of the fingertip.
On November 7, 2024, at about 12:30 PM, an employee was moving a cannon on a gantry crane when the straps holding the cannon broke and it fell. The employee was hospitalized with a crushed pelvis, multiple fractures, and other severe injuries.
An employee in the welding training booth was working to back gouge a weld on a 5mm plate. While grinding, the gouger high-centered and walked over the plate striking and severely lacerating the employee's left thumb.
An employee was walking when his foot caught residual adhesive from floor tape and he tripped and fell to the concrete floor, resulting in a fractured right hip.
An employee was adjusting a switch on the loading cradle for a metal tracer lathe. The machine cycled, resulting in an amputation to the left index fingertip.
The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.
An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.