DuPont Nutrition USA, Inc

An employee was walking down the metal stairs from the palletizing room when he fell backward onto the steps. He sustained two left rib fractures that required hospitalization.

An employee was removing T-posts from the ground when he tripped and fell on his left arm, resulting in an elbow fracture that required hospitalization.

An employee was stepping out of or into a vehicle when their foot became stuck between the curb and the vehicle, causing the employee to fall and sustain an ankle fracture.

An employee fell to the floor when her shoelace was caught on a drawer near her desk. The employee was hospitalized; she sustained a non-displaced femoral neck injury.

An employee was setting up for an event and carrying gates downhill. As the employee side-stepped down the slope, their right leg became caught in the compacted snow. The employee's momentum continued forward and their right leg remained fixed in the snow, causing fractures of the right tibia and fibula.

An employee was walking to their vehicle in the parking lot when they slipped on ice and fell. The employee sustained fractures to their left knee and ankle.

An employee was walking to their car in the parking lot. Right before getting into their car, the employee stepped on an elevated island curb and slipped and rolled their ankle. The ankle was dislocated and fractured.

An employee was using a can seamer in the research and development lab when their left index fingertip got caught between the seam press and the rotating can, resulting in a fingertip amputation.

On January 29, 2024, employee 1 was removing a 55-gallon drum from the stock area when it tipped over on its side. Employee 2 tried to lift up the drum with a forklift, but the drum slipped off the forks and crushed employee 1's right little finger. The fingertip was medically amputated.

An employee was removing parts from a sonic cleaner, which had a steel metal lid held up using hydraulic shocks. The lid came down on the employee's left little finger, resulting in amputation.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.