Nissin Foods, Incorporated

An employee was operating a soup packaging machine when the die roller amputated his right index finger.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

Two forklift drivers were stopped next to each other and were talking. The injured employee leaned out of their forklift as the other forklift was leaving and they became pinned between the two forklifts. The injured employee was hospitalized with a fractured rib and a lacerated lung.

At about 3:30 p.m. on May 8, 2025, an employee slipped and fell backward while walking around equipment. He landed on the ground, near a water trench into which a steam line and a condensation return line were piped. Hot water from the trench burned his back between the shoulder blades.

An employee was troubleshooting a motor when their right little finger became pinched between the belt and pulley, resulting in amputation of the fingertip.

An employee was driving a forklift to a shipping dock. While he was rounding a corner, a stack of totes fell, and the top of one of the totes struck the outside of his left calf. He was hospitalized.

A crew was preparing a 20-foot section of 12-inch high-density polyethylene (HDPE) pipe to be swung into a welder using an excavator, where it would be welded onto a longer run of pipe. One employee was facing the longer pipe in the welder while the 20-foot section was being rigged. The 20-foot section moved and struck the employee's left knee. The employee's left leg was broken below the knee.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.