Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at CLW, Inc., 4873 SH 146 S., LIVINGSTON, TEXAS 77351
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was attempting to pull a switch in the back of a forklift to release the brake. His hand contacted the radiator fan blade and half of his right pinky finger was amputated. The employee was hospitalized.
HospitalizedAmputationFinger(s), fingernail(s), n.e.c.Forklift, order picker, platform truck-powered
An employee was on the table of a machine. She went to jump down from the table and fractured her lower leg on the ground. The employee was hospitalized.
An employee changing out a belt on a trimmer was struck by the machine's door when it disengaged from the position in which it was propped, causing injury to the employee's left hand requiring surgery.
An employee was using a trimmer to cut sections of wood when his hand entered the blade area. At the same time, the blade activated and amputated three fingers on the employee's right hand.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.