PYCO INDUSTRIES

An employee was part of a crew that was cleaning railcars. After cleaning the last car, they were getting ready to close the back door. One of the employees had his left hand in the doorway when another employee slammed the door closed on his left ring finger. His finger was smashed, and his fingertip had to eventually be surgically amputated.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was testing a limit switch on a bale bagger. The bagger was activated and moved forward about 9 inches, pinning the employee's right hand. He was hospitalized with a broken thumb and a laceration to the hand.

An employee was operating a cyclone machine and noticed cotton hanging under the machine. As the employee went to remove it, his right thumb contacted moving parts. The employee sustained an amputation of the right distal phalanx of the thumb.

Two employees were working on a 600-amp breaker. One employee suffered an electrical shock and burns to his face, head, upper torso, and his left hand due to an arc flash.

While working in a oil mill, an employee stepped on a screw conveyor belt cover. The cover shifted, causing the employee to fall into the conveyor belt and resulting in a left ankle amputation.

An employee was repairing the drive unit on a lint beater. The machine was reactivated and its belt caught the employee's right ring finger, causing the amputation of the fingertip.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.