Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Westlake Chemical, 20043 Hwy 51, GALLMAN, MISSISSIPPI 39077
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was troubleshooting a dicer and got caught between the belt and pulley resulting in amputation of the right thumb tip and tissue damage to an index finger.
HospitalizedAmputationFingertip(s)Metal, woodworking, and special material machinery, unspecified
An employee was attempting to clear a plugged pipe when a 3/4 " threaded nipple blew out, causing the contents of the line and flush water to strike the employee. He suffered thermal burns on his abdomen, hands, and arms.
An employee was cleaning a product mixer when his hands entered the stock cutter opening. His left hand and three fingers on his right hand were amputated.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 325998)
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.
An employee was removing a hose from a chemical tank after filling the tank with hexamethylenediamine (HMD). He checked the line to ensure that the hose was clear, then disconnected the hose at the connection. Residual chemical sprayed onto his face, causing a second-degree burn. He was hospitalized.
Two employees were moving a railcar (plastic pellet hopper car) using a mobile railcar mover. One employee was the engineer in control of the railcar mover and the injured employee was a switchman. The railcar mover went forward and the hopper railcar struck the injured employee, resulting in a severe crushing injury to the employee's right arm.
An employee was opening a filter housing in the potassium chloride production area and got sprayed with a hot solution of potassium chloride brine. The employee sustained thermal burns to their right hand and legs.
An employee was performing maintenance on a guillotine cutter machine. As the employee was placing a pin in the machine, his left middle fingertip was caught, resulting in a partial amputation to the finger. The machine was not locked out at the time.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.