Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Builders FirstSource, 302 N Mile 2 1/2 E, MERCEDES, TEXAS 78570
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee's right thumb was caught and amputated by a rotating shaft in a component saw.
An employee was unloading trusses from a trailer. The trusses slid off the side of the trailer and struck the employee, who suffered fractures to the ribs, femurs, left hip, and left arm.
An employee was using a V-nailer to staple a door casing together and used his right hand to line the casing up and hold the casing in place. The foot pedal was activated and the clamp came down on his right little finger amputating the fingertip just below the fingernail.
An employee was standing on the ground beside his tractor trailer and strapping down his load. A forklift crushed him against the trailer as it backed past him. He suffered a broken pelvis and internal bleeding.
An employee was climbing an 8-foot step ladder and stopped at the second step from the top to secure a beam that a forklift was placing in the building. The beam then fell toward the employee, causing him to fall backward and hit his head on the concrete slab below. The employee suffered a fractured skull.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was spreading out wood on the live feed table. As he was operating the automatic feed saw, and the wood went in crooked and he went to straighten it. His left middle fingertip was crushed between the wood and the computer monitor. The employee's fingertip was amputated without loss of bone.
An employee was working on a conveyor belt in the chipper room that was not functioning. While inspecting the uncovered gearbox, the conveyor system started. The employee sustained an amputation to their right little finger. The conveyor system was not locked out at the time.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.
An employee was placing trusses on conveyor rollers to be stacked. The rollers could not roll the trusses, so the employee pulled the trusses onto the rollers. One of the spinning rollers caught their hand, resulting in three fingertip amputations.
An employee reached down to pick up a box next to a roller conveyor. His gloved left hand was caught in the chain and pulled into the sprocket. Three fingers were injured: the middle and index fingers were cut to the bone, and the ring finger was amputated at the nail.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.