TYSON MEXICAN ORIGINAL, INC.

An employee was attempting to unclog a pipe in the taco department line between the holding tank and the mixer when their right index finger contacted the ball valve and the pneumatic actuator cycled causing amputation of the finger between the first and second joint.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was diagnosing the cause of a rear light malfunction on a forklift when the reverse gear engaged. The forklift moved backward and contacted the employee causing a metatarsal fracture in their left foot and injury to their lower right leg.

An employee was wiping down a shredder machine while it was turned off. After she was finished cleaning, she turned the machine on when the rollers of the machine caught her fingers, resulting in amputations to her index, middle and ring fingers.

Two employees were changing fuses for a fryer. The pump on the fryer was turned off, but the heat exchanger kept running. When the pump was turned back on, hot oil shot toward the filter. The filter box opened and sprayed the two injured employees with hot grease. The employees suffered burns to their backs, shoulders, and arms.

An employee was inserting corn tortillas into a corn cutting machine. The machine's air piston released and came down onto her left thumb, resulting in an amputation.

An employee was clearing an obstruction in a conveyor when his arm was pulled into the rollers of the conveyor. He suffered lacerations to the left arm and was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.