Struck by falling object or equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at National Oilwell Varco, L.P., 201 Center Avenue, LEETSDALE, PENNSYLVANIA 15056
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was loading a roll of rubber mat into a pickup truck. The mat fell and caught the employee's finger against the bed rail. The employee suffered an amputation.
An employee was using a sledgehammer at a drilling location. The employee's finger was crushed between the hammer handle and a pad eye. The employee was transported to the hospital and the tip of their left index finger was medically amputated.
An employee was tasked with checking a centrifuge on the centrifuge stand on a drilling rig. While descending the stairs, the employee slipped and fell to the floor, sustaining a broken bone in their foot, a broken ankle, and back and chest pain.
An employee was trying to remove a plastic cover from a completed drill pipe. The coating cage basket fell on the employee's right forearm, breaking it.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.