W. T. Gardner & Sons, Inc.

An employee was putting air in a tire when it exploded off its rim and struck the employee, causing blunt force trauma.

An employee was driving an aerial lift over a cable ramp. The employee backed up the aerial lift to cross over the cable ramp. During this process, the lift and basket bounced, causing the employee to bounce and land on his right foot, resulting in a fracture to his right leg.

An employee was operating a tractor in a potato field to pack down the soil. As the tractor tires drove over uneven soil, the tractor suspension moved abruptly, causing the enclosed operator seat compartment to also move. The employee was ejected from the seat and struck their head, arm and ribs inside the tractor compartment. The employee sustained a head and arm laceration as well as rib fractures.

An employee was operating an aerial lift when it impacted a berm on the ground. The employee lost balance and struck his abdomen against the guardrail system on the aerial lift, then fell backward and struck his head against the guardrail. The employee sustained a punctured spleen.

An employee was driving a skid steer when it struck a bump, causing the boom to come down and crush his feet.

An employee was operating a skid steer with dirt in the bucket. The skid steer drove over uneven ground, causing the bucket to tilt forward and hit the ground. As a result, the employee's head struck the bar on the front top part of the cab. The employee sustained a compression injury to the neck and upper back that included two injured vertebral discs that required surgery.

An employee had dumped a load of hot mix (tar) and was cleaning the interior walls of a belly dump trailer onsite. The employee was scraping the walls of the trailer when the doors articulated, breaking the securement pin and pinching the employee's legs. The employee sustained crushing injuries and severed tendons and arteries to both legs and was hospitalized.

An employee was transferring sulfuric acid into a customer's tank. They connected the transfer hose to the receiving tank and attached the compressed air line used to pressurize the trailer. An air valve opened during unloading and a small amount of sulfuric acid got under the employee's face shield and onto their face. The employee suffered third-degree chemical burns to their face, right ear, and chest.

An employee was working to adjust a misfed pallet board that was entering the pallet board collection point. His left middle fingertip became caught between the board he was adjusting and other boards already stacked in the collection area. This resulted in amputation of the fingertip.

On July 22, 2025, at approximately 4:30 a.m. after the previous day's shift, an employee was hospitalized with a kidney injury caused by heat-related illness. The employee had worked several consecutive days delivering packages in high outdoor heat and humidity without cooling gear.

On July 18, 2025, an employee was tarping a load on a flatbed trailer in the yard. He fell approximately 13 feet off the loaded trailer and landed face-down on a gravel lot. The employee sustained facial cuts, abrasions, scrapes, fractures to their face, as well as several fractured ribs. He was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.