Struck or run over by rolling powered vehicle · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Vulcan Materials Company, 2 S Street SW, WASHINGTON, DISTRICT OF COLUMBIA 20003
on — Fractures, affecting the ankle(s).
Final narrative
An employee was standing next to the passenger side of a cement truck when the truck moved and rolled over the employee's left leg resulting in a broken ankle.
An employee had climbed a ladder to adjust brackets that were securing the boot of a down spout to a concrete portable plant. The ladder shifted and slid out from under the employee, causing the employee to fall approximately 6 to 8 feet to the ground. The employee was hospitalized with a compression fracture to his L1 vertebra.
An employee climbed onto a collector conveyor belt to pry a large rock out from under a feeder grate. The plant was started and the employee was pulled down onto the conveyor under another feeder conveyor. He fell clear after about four seconds of the belt moving under him, having suffered several broken ribs and an internal injury.
On December 26, 2023, an employee went out to the parking lot to troubleshoot the starter of an SUV. The employee was underneath the vehicle when it started and moved and the employee's middle back area was caught under the front passenger-side tire. The employee sustained a fractured collar bone.
An employee was parking at a patient's home and exited the van to manually open the garage door. The van began rolling backward and rolled over the employee's right leg. She was hospitalized with a fractured leg.
A driver exited their truck so they could provide service for a customer when the truck began to roll away. The driver went to re-enter the truck but fell and was struck by the rear driver-side tire. The employee sustained fractures to their leg and foot.
An employee had been operating a yard tractor. He parked the vehicle and was exiting when the vehicle began to roll, causing him to fall. The employee's hand was then run over by the yard tractor, resulting in fractures to multiple fingers. The employee was hospitalized.
An employee was checking for a leak in the air brake system of a semi-truck. The employee had removed the brake chamber when the truck rolled back. One of the tires pinned the employee's right hip against the ground.
More severe injuries in this industry (NAICS 327320)
An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.
An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.
A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.
An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.
A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was stocking and ordering the meat case on the sales floor when he slipped and fell due to water on the floor. The employee was hospitalized with a fractured ankle and required surgery.
An employee was working on an exhaust fan on the roof when he tripped on a wire and fell to the ground. The employee sustained scrapes on his elbow, and a fractured right knee with a torn ACL. The employee was hospitalized.