SOUTHWIRE COMPANY, LLC

On May 20, 2025, an employee was stringing up a drawing machine. He turned and his feet became tangled in the floor mats, causing him to fall and strike his knee on the floor. The employee sustained a fractured left femur.

An employee was preparing to place extruded wire onto a take-up reel using a "mule rope" affixed to the start end of the wire and had tied the other end of the mule rope to the take-up reel. The employee was using their left hand to hold the mule rope in place on the end of the wire. While the employee was jogging the reel to take the slack out of the mule rope, the mule rope tightened and pinched the employee's left index fingertip. The employee sustained an amputation of the fingertip.

An employee stopped a machine to exchange a full reel for an empty reel in the take-up. The employee rolled the empty reel into the take-up and placed the tail of the wire into the flange hole of the reel. The employee then began removing slack from the wire. As the wire tightened, it got caught on a bolt on a motor of the take-up. The wire was pulled tight and caught the employee's finger against the reel flange amputating the employee's fingertip.

An employee was lowering a spool on a take-up machine. The spool went up instead of down and pinched his left index finger against a knob. He suffered an amputation at the first joint.

An employee was changing a heat print ribbon when the print wheel was lowered onto the wire. The rolling wheel crushed the employee's left index finger, causing an open tuft fracture.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was adjusting a stretcher. Their foot went between a 3-inch opening on a press. The employee sustained an open fracture of their lower left leg above the ankle.

An employee was standing at a press machine, removing metal from a die cradle that was stuck. Once the metal was removed, the side die closed on his right wrist and lower forearm, breaking bones in the arm.

An employee was pulling metal using a tail stretcher. He pressed the double palm buttons to start the process when the clamp became stuck. The employee pulled on the metal. His left thumb was inside the clamp when it opened, cutting and amputating the tip of his thumb.

An employee was operating a 2 1/2 inch extruder press when aluminum became jammed in the press. Pressure built up and the piece of aluminum shot into the employee's left index finger, resulting in hospitalization and surgery.

An employee was operating an electric hand saw when five of their fingers were lacerated.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.