Tidy View Dairy LLC

An employee was in a cattle pen, closing a metal gate. A skid steer hit a patch of ice and slid into the gate, which swung into the employee's face. The employee suffered skull fractures, a subdural hemorrhage, and a ruptured eye, all on the left side.

An employee was in a milking parlor when he slipped and fell on a floor that was damp with water. After a couple of hours, he began to suffer a headache and head injury symptoms. He was hospitalized.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

Employees were stripping parts off an old pivot. An employee was standing on the ground, helping others make sure that the parts all came off the pivot. The pivot span was elevated when the base beam broke free on one side. This shifted the weight of the span, causing it to roll off the loader on its side. When the span came down, the support rod caught the employee's back as he went to turn and run away from it. It pushed him to the ground. He suffered a back fracture, along with a broken bone in his foot, and was hospitalized.

An employee was walking through the hospital pen and a cow struck him with her head. The employee sustained an orbital fracture.

An employee was working in a holding pen, using a crowd gate to herd cows into milking stalls. She was moving to beat the crowd gate to a manhole, but the gate moved and struck the employee. The employee was hospitalized with two fractured processes in her lower vertebrae.

Three maintenance employees were working on chemical lines feeding into a large above ground wastewater treatment tank. Sodium hydroxide and sulfuric acid reacted in a floor drain and the chemicals sprayed onto the three employees. One employee was taken to the hospital for burns to his eyes.

An employee was removing a pin from a metal gate to let cows out of a parlor. The gate moved and his left middle finger was caught in the pin hole. The employee's finger was partially amputated.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.