Fall on same level due to tripping on uneven surface · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at W.G. Yates & Sons Construction Company, 1649 West State Hwy 18, MANILA, ARKANSAS 72442
on — Fractures, affecting the ankle(s).
Final narrative
An employee was installing hardware during the construction of a bridge. While walking to get a board along the bent end (where the bridge and ground meet) the employee stepped onto uneven or loose ground, lost his balance, and rolled his ankle. The employee sustained a fractured left ankle.
An employee was walking to a customer's door to deliver a package when they tripped on uneven pavement and fell to the ground. The employee sustained a hip fracture.
An employee was walking on the sidewalk toward the front entrance of the building to start her work shift. She tripped over uneven pavement and fell onto the concrete sidewalk. The employee was hospitalized with a fractured left hip and a sprained left knee.
An employee was leaving for lunch. The wheel of her knee scooter struck a divot in the floor which caused her to fall into a metal rack. The employee sustained a broken right shoulder.
More severe injuries in this industry (NAICS 236210)
An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.
Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.
An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.
The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.
An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.