Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Autozone, Inc., 402 Stoney Creek Road, HAZLETON, PENNSYLVANIA 18202
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was working from a scissor lift to lubricate the chain and sprocket on a overhead conveyor's motor. The employee observed a rag in the conveyor. As the employee retrieved the rag, his right pinky finger got caught in the conveyor chain/sprocket resulting in a fingertip amputation.
On August 18, 2025, at approximately 7:00 p.m., an employee was working on a ladder when they fell to the floor. The employee sustained a fractured clavicle.
An employee was on a ladder outside a store. A gust of wind caught a plywood board the employee was working with, causing the employee to fall from the ladder to the ground. The employee suffered broken ribs.
On April 24, 2024, an employee was moving material in the back of a trailer. The employee fell out the back of the trailer, landed on the pavement below, and suffered rib injuries.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 423120)
An employee was descending a ladder when their foot caught on the edge of the bottom step. The employee fell and struck the floor, landing on their left hip and suffering a hip fracture that required hospitalization and surgery.
An employee had loaded parts into his van and was pulling an empty utility cart back into the store. The wheels of the cart got caught in the doorway. When the employee pulled it through, the cart fell over onto him and he fell to the floor, landing on his right hip. The employee's hip was fractured.
An employee was found on the floor within the enclosure of a laser machine. The employee was adjusting a sheet of metal on the machine while carrying a remote control, which actuated the machine, moving the carriage and causing the employee to be caught between the carriage and the machine table. The employee was hospitalized with a broken right shoulder and left ankle, and lacerations on their legs and ankles.
An employee was wrapping pallets using a plastic wrap dispenser when he felt a pop in his back along with a burning and stabbing sensation. The employee sustained the herniation of discs L4 and L5.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.