Struck by falling object or equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at ACI BUILDING SYSTEMS, INC., 10125 HIGHWAY 6 WEST, BATESVILLE, MISSISSIPPI 38606
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was moving a sawhorse when it tipped over and smashed the employee's left ring finger. The employee suffered an amputation.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.
An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.
An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.