Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Olin Corporation Winchester, 33 CR 166, OXFORD, MISSISSIPPI 38655
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was operating a full revolution press. The employee was retrieving a part from the machine in order to gauge it when the press cycled and amputated their left index finger. The press was not locked out at the time.
An employee was using needle nose pliers to remove a rifle cartridge from an adhesive pot filled with hot glue when the heat from the glue ignited the propellant powder in the rifle cartridge and caused it to burst open. Hot glue then splashed onto the employee's left arm and left hand, causing burns that required hospitalization.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332992)
An employee was loosening and removing an actuator bar retainer and retaining screws from a taper turret due to leaking oil. When the actuator broke free, their index finger became pinched between the wrench and the equipment, resulting in a partial amputation of the distal end of the finger.
An employee was troubleshooting a conveyor. The employee's left index finger was caught in the sprocket and chain and the fingertip was partially amputated. The machine was unguarded at the time.
An employee was assembling various gauge shotgun shells and loading ammunition on a line. The employee began feeling ill and experienced headaches, nausea, vomiting, and syncope. The employee was hospitalized for carbon monoxide poisoning.
An employee was unjamming a part in an ammunition collator. When the part unjammed, the wheel in the collator continued to spin, contacting their right index finger and resulting in a fingertip amputation.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.