Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at H.G. Weber and Company, Inc., 725 Fremont St., KIEL, WISCONSIN 53042
on — Amputations, affecting the fingertip(s).
Final narrative
On June 28, 2021, at approximately 1:00 PM, an employee was adjusting the timing and speed of the bundler and transport modules on a paper bag manufacturing machine. A stack of 25 paper bags became misaligned as it went onto the transport module. The employee was adjusting the stack when his right thumb was caught in the point of operation between the bundler and transport modules resulting in a fingertip amputation.
AmputationFingertip(s)Special process machinery, n.e.c.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333993)
An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.
An employee had just driven a forklift onto a trailer and was stepping down from the forklift cab onto the trailer bed. He stepped onto a chain/buckle system (used to secure the forklift to the trailer bed during travel) and fell from the deck. He suffered a head laceration and two broken vertebrae and was hospitalized.
The injured employee was leaving to go to lunch when he and another employee tried going through the office door at the same time. The employees bumped into each other and the injured employee lost his balance and fell to the ground. He was hospitalized with a broken hip.
An employee was pushing mailers when the arm/knife of a picking counter machine caught their hand. The employee suffered the amputation of their right middle finger above the knuckle. The machine was not sufficiently guarded.
An employee was using a belt sanding machine to put a 45-degree angle on the end of a metal flat-bar (1"W x 24"L x 3/8"T). The flat bar was caught between the tool-rest and the belt, causing the opposite end of the flat bar that the employee was holding to spring back toward the machine. Their left hand struck the belt/machine guard resulting in amputation of 3/4 of their little finger. Their ring finger was also lacerated.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.