Caught in running equipment or machinery during regular operation · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Builders Firstsource, 170 Elan Court, MIDWAY, GEORGIA 31320
on — Fractures, affecting the forearm(s).
Final narrative
An employee was loading lumber and gusset plates into a splicer machine which presses the plates into the lumber to connect them. The employee's forearm was caught in the point of operation when the machine started, resulting in a fractured and lacerated right forearm.
HospitalizedForearm(s)Metal, woodworking, and special material machinery, n.e.c.
An employee was unloading trusses from a trailer. The trusses slid off the side of the trailer and struck the employee, who suffered fractures to the ribs, femurs, left hip, and left arm.
An employee was using a V-nailer to staple a door casing together and used his right hand to line the casing up and hold the casing in place. The foot pedal was activated and the clamp came down on his right little finger amputating the fingertip just below the fingernail.
An employee was standing on the ground beside his tractor trailer and strapping down his load. A forklift crushed him against the trailer as it backed past him. He suffered a broken pelvis and internal bleeding.
An employee was climbing an 8-foot step ladder and stopped at the second step from the top to secure a beam that a forklift was placing in the building. The beam then fell toward the employee, causing him to fall backward and hit his head on the concrete slab below. The employee suffered a fractured skull.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321214)
An employee was spreading out wood on the live feed table. As he was operating the automatic feed saw, and the wood went in crooked and he went to straighten it. His left middle fingertip was crushed between the wood and the computer monitor. The employee's fingertip was amputated without loss of bone.
An employee was working on a conveyor belt in the chipper room that was not functioning. While inspecting the uncovered gearbox, the conveyor system started. The employee sustained an amputation to their right little finger. The conveyor system was not locked out at the time.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.
An employee was placing trusses on conveyor rollers to be stacked. The rollers could not roll the trusses, so the employee pulled the trusses onto the rollers. One of the spinning rollers caught their hand, resulting in three fingertip amputations.
An employee reached down to pick up a box next to a roller conveyor. His gloved left hand was caught in the chain and pulled into the sprocket. Three fingers were injured: the middle and index fingers were cut to the bone, and the ring finger was amputated at the nail.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.