Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Van Zyvrden, Inc., 1601 61st Place South, MERIDIAN, MISSISSIPPI 39307
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was cutting wooden boards into smaller pieces using a miter saw. The saw amputated the employee's right thumb and index finger, as well as deeply cutting the middle, ring, and little fingers.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 424910)
An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.
At about 5:30 p.m. on September 23, 2025, an employee was unloading rubber mix material from a mixer. The employee's hand was caught by rotating parts in a discharge chute, causing a partial, soft-tissue amputation to a fingertip.
An employee was walking around a customer's truck. The truck door opened and caused the employee to trip and fall on a salt pallet. The employee suffered a compound fracture to the left arm.
An employee had delivered product to a customer and was driving a forklift to the rear of the delivery truck. The forklift jumped/bounced, sending the employee up into the air and back down onto the seat. The employee sustained a back fracture.
An employee was climbing an inspection ladder to observe the inside of a hopper. He slipped on the fourth rung, fell backward, and landed on his right foot on the ground about 38 inches below, suffering a broken right ankle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.