Struck by falling object or equipment, unspecified · Fractures and dislocations
At a glance
Federal OSHA recorded a severe workplace injury
at Diversitech, LLC., 1665 Dogwood Dr. SW, CONYERS, GEORGIA 30012
on — Fractures and dislocations, affecting the ankle(s) and leg(s), n.e.c..
Final narrative
An employee was cutting a wire rope on a plastic bale. The bale uncompressed and fell over onto the employee's left leg and ankle. The employee suffered a broken tibia and a left ankle dislocation.
HospitalizedAnkle(s) and leg(s), n.e.c.Bundles, bales
An employee was troubleshooting a cutter machine to see why the blade was not spinning. The power button on the machine was pressed and the blade contacted his right little finger, resulting in a laceration and an amputation. The machine was energized at the time of the incident.
An employee was clearing tubing from the cutting area of a machine cutter. The cutter activated, causing an amputation to the employee's left middle fingertip.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee was removing product (a transformer radiator weighing approximately 2,640 pounds) from the paint room utilizing an overhead drop-crane system. The employee inspected the product in the drop section and started to lower the load. The product fell out of the rigging and hit the ground. It then tipped, pinning the employee against a desk. The employee was hospitalized with collapsed lungs, a dislocated sternum, a head injury requiring staples, and fractures to their ribs and wrists/lower arms.
An employee was retrieving an empty blue bin. When he turned around, he tripped over a skid and fell to the floor, striking his head and sustaining injuries to his hip and foot. The employee was hospitalized with a fractured left hip.
An employee was troubleshooting a cutter machine to see why the blade was not spinning. The power button on the machine was pressed and the blade contacted his right little finger, resulting in a laceration and an amputation. The machine was energized at the time of the incident.
An employee was operating a horizontal press. As the employee reached for their work badge, the press cycled onto their little finger and amputated a quarter-inch of the tip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.